#BEAGLEBONE BLACK DRIVER WINDOWS 10 HOW TO#
#BEAGLEBONE BLACK DRIVER WINDOWS 10 INSTALL#
#BEAGLEBONE BLACK DRIVER WINDOWS 10 DRIVERS#

What you need to do is direct any data destined for the internet through a gateway, which is your computer at IP address 192.168.7.1.

#BEAGLEBONE BLACK DRIVER WINDOWS 10 HOW TO#

Now that everything is setup ok, you now need to tell the BeagleBone Black how to connect to the internet. You should see an output on the screen, which is a response from your computer to say everything is ok. The ping tool is essentially a debugging tool that tests the TCP/IP connections between devices. To test this connection, you can simply issue a ping command from the shell prompt: The IP address or the Gateway for the virtual network connection over USB is 192.168.7.1. The first step you will want to do is make sure the USB connection between the BeagleBone Black and your computer is working ok. Depending on which version of the Linux you are using on the BeagleBone you should see the window in the below figure.Д¬onnecting the BeagleBone Black to the Internet via USB Port

Enter a default password if requested to login. You can see the settings in the figure below.Д¬lick вЂњOpenвЂќ and a new window will open with the BeagleBone shell terminal.

Also make sure the port number is 22 and the connection type is set to SSH. Once opened, in the вЂњHost Name (or IP address)вЂќ box enter the local IP address of the BeagleBone Black, which is the same as what you typed into the web browser earlier. Once downloaded you should be able to run the executable file from the folder you downloaded it to. You can download PuTTY from the web link below: There are many other clients out there but PuTTY gives us a simple interface to work with and is most reliable when using the program. In order to use SSH on a Windows computer you will need to download an SSH client such as PuTTY. One of the best ways to connect to your BeagleBone board and start issuing commands from the command line it to use shell prompt. You should see the BeagleBone home page and your device successfully connected.

#BEAGLEBONE BLACK DRIVER WINDOWS 10 DRIVERS#

Once the drivers have been installed a simple reboot may be required and you should be able to open up your web browser (Firefox or Chrome recommended) and navigate to the BeagleBoneвЂ™s on board server at the following web address.

#BEAGLEBONE BLACK DRIVER WINDOWS 10 INSTALL#

If you havenвЂ™t done so already you will need to install the serial drivers for your operating system from this flash drive. The BeagleBone board should show up on your computer as a USB flash drive. This should power the board up and also provide communication between the board and your computer. The first thing you will need to do is connect your BeagleBone Black board to your computer using the USB port. I was able to use my wireless internet on my laptop computer and share this with the BeagleBone with only a few steps. However, I soon came across a solution in the forums and it worked a treat. I found myself in this situation not too long ago and all I wanted to do was run a few updates and install some software, yet I spent far too long pondering the solution to this issue. Even with the single USB port taken up by other peripherals a wireless dongle also may not be an option for most users. Like most makers, the ability to connect your projects to the internet greatly expands its capabilities and whilst the BeagleBone Black development board has an Ethernet jack sometimes it is not always possibly physically to connect your board to the internet.

Beaglebone black driver windows 10